superart
Mechanical
- Jan 16, 2009
- 46
I am trying to run FlowXpress on a model, and I can get it to start solving, but as it gets to the end of the meshing stage, it just stalls.
I'm not sure why it does this, and it is only with this particular model that it is doing it. I am able to get it to run just fine on other models. I don't think it is a hardware limitation, since my CPU and memory are nowhere near maxed out.
I attached a screen shot of what I am getting, as well as the model itself. Thanks in advance for any help that I can get on this.
--Art.
I'm not sure why it does this, and it is only with this particular model that it is doing it. I am able to get it to run just fine on other models. I don't think it is a hardware limitation, since my CPU and memory are nowhere near maxed out.
I attached a screen shot of what I am getting, as well as the model itself. Thanks in advance for any help that I can get on this.
--Art.