Flyouts flying away

[dedevo]

The flyouts I'm talking about are like those in Weldments, the little grey boxes when you trim/extend:
[ Body 1,1: keep ]

When I click on one, they all jump to the other side of my model. Then I'm forced to pan around until I find them, and by that point I can't even see which tail goes to which cut section.

Is there a way to force pull them all back to the screen?
Or is there a way to have them more intelligently show up?

Devon Murray, EIT [Mechanical]
Solidworks 2011 SP 2.0

 

[JMirisola]

They jump when you click on one? That's odd to say the least. My initial reaction is graphics card. Double check that you're good in that area, unless you know of other people with the same issue. If the latter is true, it may be a bug.

Jeff Mirisola, CSWP
Design Manager/Senior Designer
M9 Defense
My Blog