Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

follower traction

Status
Not open for further replies.
srikanth1983

srikanth1983

New member
Mar 24, 2010
6
0
0
IN
i have a cantilever plate. one end of the plate is fixed and the other end has a follower traction pressure applied of 100 MPa. how do you apply follower traction in NX /? is it right to use sol 601 for this analysis ? if possible, please put screenshots. thank you.
 
Status
Not open for further replies.

Similar threads

spikefer
  • Locked
  • Question
Follower Forces in NX NASTRAN
Replies
1
Views
2
nlgyro
nlgyro
Back
Top