Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Forging analysis in Abaqus

Thread starter B1ackMi16
Start date Feb 7, 2008

Status: Not open for further replies.

Feb 7, 2008

B1ackMi16

Structural

I just wonder if Abaqus can be used to analyze drop forging of 3D models in a good way?

I know there's programs like Deform 3D, and Forge that are made just for this purpose, but it is possible to use abaqus?

If it is, any ideas where to find a turtorial on this?

Regards

Kristian