Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Format and Drawing Issues

Status
Not open for further replies.

looslib

Mechanical
Joined
Jul 9, 2001
Messages
4,205
Location
US
When we changed from WF3 to WF4, but still on PDMLink 9m050, the parameters when we create a new drawing are not being transferred the way they were with WF3. In WF3, the parameters would load across from the model file, but in WF4, we are asked to enter each parameter value. Has anyone else seen this with WF4?


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
We don't use PDMlink or any data management tool, but with WF4 M170, we don't have any problem with our model parameters filling in the formats.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top