Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Forming a Flange Using NX3 Sheet Metal

Thread starter Dave11223344
Start date May 21, 2012

Status: Not open for further replies.

May 21, 2012

Dave11223344

Industrial

I am new to NX3 sheet metal. I cannot get the progrqam to allow me to actually select an edge to begin a simple flange on a sheet metqal part. I created the flat original extrusion in sheet metal.
I have been using the flange feature in UG instead but I cannot get edge relief features this way, etc.
Can anyone help?
Dave11223344