I'm modifying a UMAT subroutine and I'm getting a seg fault-type error from Abaqus when it runs. It's proving pretty difficult to figure this out, and I think it would be helpful if I could turn on bounds checking or similar options when Abaqus calls the Fortran compiler for my subroutine. Is this possible? If so, what would be some good options to use?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fortran compiler options
- Thread starter andrewcm
- Start date
Similar threads
- Locked
- Question