velickovic
Structural
Hello, I am interesting in the fracture toughness characteristics for the steel with DIN 17007 designation 1.7147 or with DIN 17006 designation 20MnCr5
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
fracture toughness
- Thread starter velickovic
- Start date
- Status
chrisbullough
Materials
According to Stahlschlussel (1995), the minimum RT Charpy V properties for the 1.7147 case hardening steel should be 34J and 34J for 11mm and 30mm section, respectively.
These values are identified as "after case hardening, in core". Clearly, the values of your actual material may be somewhat affected by the processing route.
If you need K1C/K1J values, I suggest you test some actual material (best), or ask your supplier for values.
These values are identified as "after case hardening, in core". Clearly, the values of your actual material may be somewhat affected by the processing route.
If you need K1C/K1J values, I suggest you test some actual material (best), or ask your supplier for values.
- Status
