JUICESEAUS
Industrial
- Jun 17, 2009
- 2
Hello,
I have several times had inventor seize up during a prompted recovery. Usually minor adjustments in constraint or sketch projection. The real frustration is that the whole program goes to Non-responsive mode...I have to override with Task Manager to shut down and start over...usually.
Any input is appreciated,
j
I have several times had inventor seize up during a prompted recovery. Usually minor adjustments in constraint or sketch projection. The real frustration is that the whole program goes to Non-responsive mode...I have to override with Task Manager to shut down and start over...usually.
Any input is appreciated,
j