Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

friction/angle on coneshaped fastener (lockpin)

Status
Not open for further replies.
770213

770213

Mechanical
May 22, 2002
4
How do you calculate the angle on a cone shaped fastener that is used as a lockpin, the angle so that it isnt jammed (friction) when it is to be retracted??

Many thanks / Joe
 
Status
Not open for further replies.

Similar threads

KVARM
  • Question
Aluminum Angle Rolling
Replies
3
Views
931
3DDave
3DDave
Joccob
  • Locked
  • Question
Simple Coefficient of Friction Calculation / Principle Behind Friction Test Machine 1
Replies
14
Views
322
btrueblood
btrueblood
FootLoose
  • Locked
  • Question
Multi surface friction calculation
Replies
4
Views
151
desertfox
desertfox
Cilasefi7
  • Locked
  • Question
Question about wheels to use for moving a fixture on an 1/2'' angle rail 9
Replies
17
Views
445
Artisi
A
elinah34
  • Locked
  • Question
Increasing a coefficient of friction between 2 surfaces 3
2
Replies
26
Views
536
elinah34
elinah34

Part and Inventory Search

Sponsor

Back
Top Bottom