Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

From workbench to Ansys

Thread starter cuteice
Start date May 7, 2007

Status: Not open for further replies.

May 7, 2007

cuteice

Mechanical

Every time I transfered the generated model(geometry,mesh,boundary condition) from workbench to Ansys and tried to run in Ansys, the Ansys program suddently crashed and terminated. How could I solve this problem?
And who could instruct me the difference between workbench and Ansys?