Jan 31, 2007 #1 vptob Mechanical Jan 31, 2007 1 Can anyone provide tips on how to prevent galling when machining Inconel parts?
Jan 31, 2007 #2 MechanicalChef Mechanical Oct 18, 2005 141 This is probably a no brainer question, but how is your tool condition, and how are your feeds and speeds? Upvote 0 Downvote
This is probably a no brainer question, but how is your tool condition, and how are your feeds and speeds?
Jan 31, 2007 1 #3 kenvlach Materials Apr 12, 2000 2,514 See Machining from Special Metals: http://www.specialmetals.com/documents/machining.pdf The various Inconel alloys fall into machining groups 'C' and 'D2' in the above manual. Also, get info for the particular alloy: http://www.specialmetals.com/products/ Upvote 0 Downvote
See Machining from Special Metals: http://www.specialmetals.com/documents/machining.pdf The various Inconel alloys fall into machining groups 'C' and 'D2' in the above manual. Also, get info for the particular alloy: http://www.specialmetals.com/products/
Feb 24, 2007 #4 BaxterBee Industrial Nov 2, 2006 1 Its trial and error at best sometimes, try a higher feed rate and slower speed. Again depends on what your trying to do, turn, mill, thread etc........ Upvote 0 Downvote
Its trial and error at best sometimes, try a higher feed rate and slower speed. Again depends on what your trying to do, turn, mill, thread etc........
