APPENG
Mechanical
- Jan 22, 2002
- 366
Good afternoon,
I have created a library of parametric notes for my designers to use when creating the detail drawings.
These notes contain the usual text, links to custom properties & special properties. They also have GD&T frames, And surface finish symbols.
Everything works except for the symbols and GD&T
When I drag in the notes, the GD&T frame is not there. In its place there is text that says "#error: broken link"
This is what I created:
Here is what I get when I drag it into the drawing:
Anyone else having this problem?
Regards,
Jon
I have created a library of parametric notes for my designers to use when creating the detail drawings.
These notes contain the usual text, links to custom properties & special properties. They also have GD&T frames, And surface finish symbols.
Everything works except for the symbols and GD&T
When I drag in the notes, the GD&T frame is not there. In its place there is text that says "#error: broken link"
This is what I created:
Here is what I get when I drag it into the drawing:
Anyone else having this problem?
Regards,
Jon