GD&T Feature Control Frame Formatting 2

[MadMango]

I think this is more a SW question than a GD&T question.

I am trying to make a feature control frame similar to Fig 6-15 (p.106) in ASME Y14.5-2009, perpendicularity of an axis with zero tolerance at MMC with a max tolerance specified. I can't seem to get the MMC symbol between my zero tolerance and my max tol in a single feature frame. Any work arounds?

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?

 

[vigildesign]

Cut and paste in the symbols: <MOD-MMC> for MMC and <MOD-DIAM> for the second diameter symbol.

 

[fcsuper]

That's good call there, vig. This might be worth of the Hidden Commands list.

Matt Lorono, CSWP
Lorono's SolidWorks Resources & SolidWorks Legion
Follow me on Twitter

 

[MadMango]

I'm not quite getting this. I can't seem to Cut & Paste in the Gtol Property pop-up box.

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?

 

[fcsuper]

Mad,

Don't cut and paste. Just type the tags directly into the edit field where you enter the number values. I just tried this and it works well.

Matt Lorono, CSWP
Lorono's SolidWorks Resources & SolidWorks Legion
Follow me on Twitter

 

[MadMango]

VigilDesign and Matt, got it!

"Art without engineering is dreaming; Engineering without art is calculating."

Have you read faq731-376 to make the best use of these Forums?