I am setting a GE D60 relay and trying to get some clarification on what the intent is for this OFFSET setting and how to set it. I usually use SEL relays. The GE manual doesn't go in detail about this setting. I do not have series compensated lines. Any help would be appreciated. Attached below is a pic of the D60 settings section for the Neg Seq Dir Offset setting.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
GE D60 Neg. Seq Directional OC- Offset setting
- Thread starter Uquresh1
- Start date
Similar threads
- Question
- Locked
- Question
- Locked
- Question