Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
GEC EM85 Gas Turbine Manual
- Thread starter Kiani1982
- Start date
I suggest that you contact Greenray Engineering
The offer legacy report for these turbines
The offer legacy report for these turbines
- Thread starter
- #3
Hello Hoxton,
Thank you so much for your swift response.
Unfortunately Greenray will not support this info to me, just I want to know how much is Turbine Inlet Temp (TIT) for EM85 and which material historically/technically used for Combustion Turbine stators Vanes 1/2 in the EM85.
We deal with a Non OEM, MFG for CT stator vanes 1&2 that the MFG made these vanes with Nimonic80A material, but the end user said Nimonic80 not suitable for this engine CT vanes 1/2 and should be use Inconel 738, Finally I want to know what I can do and who are right, becuase the MFG saying Nimonic80A is fine for CT Vanes 1/2.
Just we know Turbine Vanes Thermocouple show us 780 C during normal operation of GT.
Please send me your email address and cell No.
Regards,
Kiani
Thank you so much for your swift response.
Unfortunately Greenray will not support this info to me, just I want to know how much is Turbine Inlet Temp (TIT) for EM85 and which material historically/technically used for Combustion Turbine stators Vanes 1/2 in the EM85.
We deal with a Non OEM, MFG for CT stator vanes 1&2 that the MFG made these vanes with Nimonic80A material, but the end user said Nimonic80 not suitable for this engine CT vanes 1/2 and should be use Inconel 738, Finally I want to know what I can do and who are right, becuase the MFG saying Nimonic80A is fine for CT Vanes 1/2.
Just we know Turbine Vanes Thermocouple show us 780 C during normal operation of GT.
Please send me your email address and cell No.
Regards,
Kiani
- Status
Similar threads
