Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

General table Equation functions

Thread starter NTME76249
Start date Jan 21, 2015

Status: Not open for further replies.

Jan 21, 2015

NTME76249

Mechanical

I am trying to figure out how to convert a single cell in a general table from a decimal to a fraction. I don't want to mess with my document properties and that does not really work anways since this is an calculated value. I figured this out in excel but the general table is greatly limited in the equation dept.
I just thought i would throw this out and see if any one had any ideas?

Michael McMillan

http://www.linkedin.com/pub/michael-mcmillan/53/375/52b