Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Generate Numbering default status

Status
Not open for further replies.
morauski

morauski

Automotive
Dec 21, 2008
20
Once you have used "Generate Numbering" if you run it again it defaults to "Replace" numbers. Is there a way to have it default to "Keep"? This illogical approach as caused problems that I would like to avoid in the future.
 
Status
Not open for further replies.

Similar threads

Bombas
  • Locked
  • Question
Annotaion Ballon default settings
Replies
1
Views
56
Little Cthulhu
Little Cthulhu
Hix066
  • Locked
  • Question
Modify the default CATPart / CATProduct?
Replies
1
Views
68
Little Cthulhu
Little Cthulhu
MShetty
  • Locked
  • Question
Generate Adaptive Sweep using macro
Replies
0
Views
32
MShetty
MShetty
706Jim
  • Locked
  • Question
Catia drafting default dimension change
Replies
3
Views
113
706Jim
706Jim
John Jr
  • Locked
  • Question
Hidden Lines off by Default
Replies
3
Views
68
Wuzhee
Wuzhee

Part and Inventory Search

Sponsor

Back
Top Bottom