Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Generating a solid volume of a propeller for CFD ?

Status
Not open for further replies.

mmn1239

Mechanical
Joined
May 8, 2011
Messages
1
Location
US
Hello,

I downloaded a solid works file of a propeller from ( try to mesh in Gambit for a cfd project (due to the many sharp angles meshing was proving quite difficult). I initially just imported it into gambit as a parasolid as is and tried different clean up tools, but to no avail. So, now I am trying to obtain just an solid volume version of the prop in solidworks to export. I have tried knitting all the surfaces, but am having issues with the fill option. The make solid option is not available in the insert/boss menu, so I know something's up.

Let me know if anyone has any suggestions,

Thanks
 
You may need to recreate/simplify some geometry to make it solid. Haven't looked at your model, but try with one blade first, and pattern it. Best bet may be to get one blade solid, pattern as needed, and do a combine with the base at the end.

James Spisich
Design Engineer, CSWP
 
This model is such poor quality that I would start over from scratch - it isn't even symmetrical.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top