Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Get graphics window corner coordinates

Thread starter erpj
Start date Nov 13, 2017

Status: Not open for further replies.

Nov 13, 2017

erpj

Aerospace

Hi,

Is there a way to obtain the corner coordinates of the currently displayed graphics window through NXOpen?
I am working on a journal to automate the insertion of a PMI note in the graphic window and would like the note to be as close as possible to the corner (after a view fit).

Thanks,
Etienne

Etienne
NX 10.0.3.5 + TC 12.2.2.1