CheeseMaker13
Aerospace
Right basically I currently have a set of parts that are modeled using a 'local' axis.
However, I need to use another point/origin (actually another axis) to actually calculate the CofG.
Manually I click on the Inertia tool, create a point using the calculated CofG location using 'Create Geometry' then measuring to the other origin for delta X, Y & Z.
Is there a way of doing this with VBA? The point that it needs to be measured from/to isn't in any of the parts.
Thoughts?
However, I need to use another point/origin (actually another axis) to actually calculate the CofG.
Manually I click on the Inertia tool, create a point using the calculated CofG location using 'Create Geometry' then measuring to the other origin for delta X, Y & Z.
Is there a way of doing this with VBA? The point that it needs to be measured from/to isn't in any of the parts.
Thoughts?