getting mid-side nodes to follow geometry ?

[rb1957]

in a solid model, TET meshing gives me TET10s (I guess that a default somewhere). At a hole, the corner nodes follow the hole bore, but the midside nodes don't (they're at the geometrical average of the corner nodes.

Is there some way (without editing the nodes by hand) to get the midside nodes to map to the hole bore surface ?

another day in paradise, or is paradise one day closer ?

 

[rb1957]

found it (I think) … mesh creation/midside_nodes/options ...

another day in paradise, or is paradise one day closer ?