Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Getting previous command with up arrow key?

Status
Not open for further replies.

danieldoral

Structural
Aug 11, 2002
32
Hey ...

Another question......

Im using autocad LT at work and 2000 at home.

At home i can if i had used a command eg. trim and then extend, and then wanted to use the extend command again i would just have to use the up arrow key to scroll back to one of the previous commands,
However this does not work at work.

Is this one of the limitations of LT or can i tweek this preference ??

Thanks

Daniel Luke
daniel@akiworld.com
 
Replies continue below

Recommended for you

Yes, this is a limitation of LT. And no, you can't tweek it.
Sorry guy.
Rich
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor