Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Gouge checking

Thread starter kukelyk
Start date Feb 7, 2013

Status: Not open for further replies.

Feb 7, 2013

kukelyk

Industrial

What clearances and tolerances is the Gouge checker using? Is there a tool holder and shank safe distance for the IPW during 2D dynamic verifying? Why varies the number of collisions, if I run Gouge check more times? When verify says No collisions, why says Gouge check there IS collisions? Are the 10-parameter tools supported?
In which should I trust? [mad]