Hello,
I am looking to make a custom material addition for GPO-3 (Glastic) in Autodesk Inventor so I can do some stress analysis. I am having a hard time finding all of the properties that Inventor would require for GPO-3 material. These are the properties that are required for the material properties:
Thermal Conductivity
Specific Heat
Thermal Expansion Coefficient
Young's Modulus
Poisson's Ratio
Shear Modulus
Density
Yield Strength
Tensile Strength
I am able to find some of the values, but there is not a great deal of consistency with the values given from site to site. Just wondered if anyone knew of a website/company that had consistent dats for GPO-3.
Thanks
I am looking to make a custom material addition for GPO-3 (Glastic) in Autodesk Inventor so I can do some stress analysis. I am having a hard time finding all of the properties that Inventor would require for GPO-3 material. These are the properties that are required for the material properties:
Thermal Conductivity
Specific Heat
Thermal Expansion Coefficient
Young's Modulus
Poisson's Ratio
Shear Modulus
Density
Yield Strength
Tensile Strength
I am able to find some of the values, but there is not a great deal of consistency with the values given from site to site. Just wondered if anyone knew of a website/company that had consistent dats for GPO-3.
Thanks
