Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

group constraint between FE part and solid part in MSC ADAMS

Thread starter Mohammad reza36674
Start date May 24, 2022

Status: Not open for further replies.

May 24, 2022

Mohammad reza36674

Student

hi , how can i create constraint between a rope that is a FE part and a non circular pulley that is solid ,while the rope cross along the path on non-circular pulley.thanks a lot.
the pic is my non_circular pulley that i need creat a rope while cross along the blue curve path on non-circular pulley