Group Features NX6

[jerry1423]

I am trying to use "group features" in NX6 and the "ok" and "apply" buttons are greyed out.
They are greyed out from when I just get into the command to after I select the features.
It appears to me that this command is turned off (I really haven't used this for a while) - Is there a setting to turn it on? I can't seem to find it.

 

[jerry1423]

I just discovered something.
This is somebody elses part that I was asked to looked at and
it consists of a few differnt bodies in one file.
I guess "group features" worked when there was only one body in the file,
but not after the other bodies where created in the file.

 

[JohnRBaker]

That shouldn't matter. Make sure that you've entered a name for the group at the top of the dialog. Unlike the old group object command, you can't create unnamed 'Feature' groups.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

UG/NX Museum:

http://www.plmworld.org/p/cm/ld/fid=209

To an Engineer, the glass is twice as big as it needs to be.

 

[jerry1423]

That was it. Thank you.