Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Guardrail design

Status
Not open for further replies.

MrKid

Structural
Jan 4, 2012
1
Cal Osha Construction Safety Orders requires guard rails/posts to hold a minimum 200lb load in any direction without "failure" (key point here) It also refers to the use of "select lumber" as defined by the Safety Order which defines the lumber in the Westerns Woods Grading book with a value of 1500 psi material. Which without any factors would require the use of Douglas fir "Select" lumber. However if you test the lumber to failure ( which is specified in the Cal OSHA Construction Orders) would allow the use of a lower grade lumber. Testing to failure also allows for severl less nails as apposed to an engineered design. The Safety Orders do not address the allowable stresses for design.
So what does industry use for allowable values for nails/ screws/lumber, steel etc in the design of guardrails when they treat an allowble test to 200 lbs without failure as acceptable?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor