Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

halting analysis if a nodal value is reached 1

Status
Not open for further replies.

cagrisever

Automotive
Jul 12, 2005
6
TR
I'd like to stop the simulation when nodal tempeatures at a region reach a predefined value. I had a look at 6.6 documentation and have some idea as:

*EXTREME VALUE, HALT=YES
*EXTREME NODE VALUE, NSET= , TEMP MAX=800

However, documentation is not so obvious in this subject. Could you please help with that. Do you think the above statement will work with a transient solution or do you have another idea.
Thanks for your time.
Cagri Sever
 
Replies continue below

Recommended for you

Hi

Looks pretty easy to use to be honest;

*EXTREME NODE VALUE, NSET=MyNodes
NT, 800

The key is setting the right output identifier and value on the data line. Section 4.2.2 of the Analysis Users Manual covers the available output identifiers quite well.

Regards

Martin
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top