May 18, 2011 #1 thwainy Mechanical May 18, 2011 5 Hi, Can you get me an idea for bending 30 mm hardox plate in my shop? thnx
May 18, 2011 #2 vthomidis Mechanical Jun 17, 2010 73 It depends on some factors mainly what type of hardox it is ( hardox 400 , hardox 500 or.....) This link will be of great help : http://www.scribd.com/doc/55685193/Bending-Hardox-and-Weldox Upvote 0 Downvote
It depends on some factors mainly what type of hardox it is ( hardox 400 , hardox 500 or.....) This link will be of great help : http://www.scribd.com/doc/55685193/Bending-Hardox-and-Weldox
May 18, 2011 Thread starter #3 thwainy Mechanical May 18, 2011 5 Thanks vthomidis, I tried the instructions as attached, but the stock get break always. Do I have preheat it prior to bending it? Upvote 0 Downvote
Thanks vthomidis, I tried the instructions as attached, but the stock get break always. Do I have preheat it prior to bending it?
May 19, 2011 #4 vthomidis Mechanical Jun 17, 2010 73 .....I think you may need to contact the technical support of the manufacturers - see their email in this link : http://www.ssab.com/en/Service/Knowledge-Service-Center/Forming/ I know they are always very keen in helping out. Upvote 0 Downvote
.....I think you may need to contact the technical support of the manufacturers - see their email in this link : http://www.ssab.com/en/Service/Knowledge-Service-Center/Forming/ I know they are always very keen in helping out.
