Hatch problem?

[Kth]

Every time I updated my view in UG-Drafting section my hatch change to 75 or 135 degree. I want the default to be 45 degree.
I use Preference annotation fill/hatch to set the angle

thanks kth

 

[Xwheelguy]

Check to see if you have Assembly Crosshatching turned on in View Preferences. If you do, turn it off & see if that helps.

Tim Flater
Senior Designer
Enkei America, Inc.

http://www.enkei.com

 

[Kth]

Thanks for the tip Tim.
I have tried but it still changes the entire hatch every time the view is updated. It is like this commando is turned on all the time?