Hatch turned off...how do I get it back?

[Runz]

If you go to the hatch properties and change it to "none", how do you get it back?

 

[catiajim]

You can search for Area Fill's via the Edit Search function. Then you can get to the properties by using Alt-Enter. If you have multiple area fills on the drawing, click-drag an area around the one in question first. Then key in the following in your power command window:
T:Area Fill, sel
This will do an EDIT, SEARCH, TYPE Area Fill within the current selection.

 

[Runz]

I couldn't get either to work, then I realized its not an "Area Fill"...hatching is a "Generated Shape".

The power command you mentioned didn't seem to work, because there was no hatch highlighted/selected to right mouse click and change the properties. However, with the edit/search, I was able to find the missing hatch and turn it back on.

Thanks,