Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hatching???

Status
Not open for further replies.

Slaen

Automotive
Jan 23, 2005
128
I am trying to print a Drawing with hatch marks.
The hatch marks show in Preview but will not show in the print.

Has anyone seen this before?
This is repeatable in 16,17,18 and I am going to try 19 right now.
 
Replies continue below

Recommended for you

Have you went to properties (of the hatching) and tried upping/lowering the pitch... to make it more/less dense of a hatching??? Is the area your trying to hatch/see outlined in a deep bold line???
 
Yeah Ive tried that and I have also tried various hatch lines with no luck.
 
Is it a printer language issue? Have you tried other printers?
 
sort of a workaround but what about saving as pdf or some other format (where, hopefully, the hatching shows up) and printing from that?

 
I could try saving it out as a pdf.
But I have tried multiple printers

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor