Hazardous Location Sump Pump

[KenRad]

I'm looking for a sump pump for a sink in a hazardous (Class 1 Div 1) location. Several manufacturers make submersible pumps that are rated for this, but the ones I've seen are too large for this application. Anyone see any small ones?

---KenRad

 

[PEDARRIN2]

Try Zoeller - they have pumps (X6160) down to 1/2 HP for Class 1, Div 1.

 

[KenRad]

PEDARRIN2,

I looked at those. While they would do the job, I was looking for something that wasn't 2' tall, and didn't need a 2' diameter sump. Hoping to find something that will fit under the sink. Since I haven't found anything on the Internet, I knew it was a longshot.

---KenRad

 

[dicksewerrat]

Try Flygt pumps?

Richard A. Cornelius, P.E.

http://WWW.amlinereast.com

 

[hydrae]

Does it need to be a 'solids' sump pump?
if under a sink and just pumping the sink's waste then the passing sphere size could be quite a bit smaller and then you a just looking for a submersible pump.

Hydrae

 

[dicksewerrat]

WHY is under the sink in an explosive environment?

Richard A. Cornelius, P.E.

http://WWW.amlinereast.com

 

[KenRad]

dicksewerrat - The entire room (where the sink is located) is Class 1 Division 1. Hence the need for a pump that is rated accordingly.

hydrae - Don't need a solids pump, just a submersible. Still haven't found a small one for this service (Class 1 Div 1).

---KenRad