CarlPoplawsky
Mechanical
Can anybody provide a source for HDPE creep constants compatible with the Maxwell-Kelvin creep model in Nastran SOL106 or Power Law constants?
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
HDPE Creep Properties
- Thread starter CarlPoplawsky
- Start date
- Status
The Polyethyline Pipe Institute has some good design information on high density polyethelyne. Their website is Search their website for "PPI Handbook of Polyethylene Pipe." I believe Chapter 3, Engineering Properties, will have what you are looking for.
- Thread starter
- #3
CarlPoplawsky
Mechanical
This is very helpful; thankyou. If I read this correctly, the article advocates use of a tensile creep modulus (Figure 11) to run static stress at discreet time points, to obtain strain. Do you concur?
- Status
Similar threads
- Locked
- Question
- Locked
- Question