Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Heat Transfer

Thread starter Bobfromoh
Start date Jul 21, 2009

Status: Not open for further replies.

Jul 21, 2009

Bobfromoh

Mechanical

When insulation is applied to a cylinder, how is the interface modeled. I can't get the temperature to distribute properly. The ID is at 500F on a steel shell. The outside of the insulation has a film coefficient. After the analysis, the 500 F goes thru the metal with no reduction. The ID of the insulation is 500F. Then the insulation OD is much less. Is there a secrete to putting two materials together?

Thanks.