Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

HEC-HMS warning 12050

Thread starter DPAJR
Start date Dec 9, 2009

Status: Not open for further replies.

Dec 9, 2009

DPAJR

Civil/Environmental

I have a project of 500 acres. The terrain is very irregular. I divided the Basin into 7 subbasins. There are seven reaches all located in downstream subbasins. The upstream subbasins are connect directly to reaches located in a central basin which is surrounded by higher ground. Whenever I load the project I get 7 warning messages, one for each subbasin.

"Warning 12050 unrecognized parameter in basin model "Basin 1"
Section begins with label "Reach 1"
Line contents are "channel:kinematic wave"

Any help would be a lifesaver.

Thanks
dpajr