Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Helical Compression Springs in Hydrogen Service

Status
Not open for further replies.

Sullivan4874

Mechanical
May 24, 2021
10
What are the recommended materials for wetted helical compression springs in hydrogen service? I've read that Elgiloy and MP35N are good. What about Inconel X-750 with precipitation heat treatment (4 hours @ 1200F)? Any others?

Thanks!
 
Replies continue below

Recommended for you

'Hydrogen service'...

Room temp? High temp? Cryogenic?

Pure H2... or compounds of hydrogen H**['sour']?

Regards, Wil Taylor
o Trust - But Verify!
o We believe to be true what we prefer to be true. [Unknown]
o For those who believe, no proof is required; for those who cannot believe, no proof is possible. [variation,Stuart Chase]
o Unfortunately, in science what You 'believe' is irrelevant. ["Orion", Homebuiltairplanes.com forum]
 
Pressure - up to 1500 psi
Temperature - 0 to 120F
Hydrogen concentration - 5% to 100% with the balance being clean natural gas

Thanks!
 
Inconel 718 might also be an option. It is used for critical fasteners in nuclear, so it has been studied to death.

"Everyone is entitled to their own opinions, but they are not entitled to their own facts."
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor