Helical swept cut 1

[Fonzee]

I am trying to create a cut on the edge of a cylinder, but I can't seem to sketch the cut path parallel to the center axis. (basically creating a bolt) Any ideas? Thanks!

 

[dgallup]

Just do a helical sweep. Make your path on any plane that is through the axis.

 

[cadcamguy]

this may help

http://www.proengineertips.com/part-design/tutorial-create-spring-using-helical-sweep-in-pro-e.html

 

[Fonzee]

Another question on making a spring, is it possible to have the ends of the spring end at opposite sides?

 

[cadcamguy]

is it possible to have the ends of the spring end at opposite sides


if I am understanding you correctly .. it would mean you would just have to work out your pitch and spring length