Help for flexray simulation!!!

[dimdim1979]

I started this project with a simple idea to decrease wires in the car but I had not any idea that this it was so developed when I started to look on the internet. The aim of my project is to simulate one of two communication
systems (i.e. FlexRay, byteflight). The software tools that I have are the
MatLab and the LabView. please it is important. If anyone has simulation examples please contact with me


Yours sincerely,
Dimdim1979.

 

[MacGyverS2000]

If you're looking for automtoive busses that reduce wire count, you nee to be looking at something like CAN.


Dan
Owner

http://www.Hi-TecDesigns.com

 

[VEBill]

I looked up the two mentioned (FlexRay and byteflight) and they are both The Next Generation of automobile bus standards (moving beyond CAN).

 

[MacGyverS2000]

Ahhhhhh, so maybe it' ME who should be doing the research. I'm actually going to look them up, as they may be useful in later projects... thanks Bill.


Dan
Owner

http://www.Hi-TecDesigns.com

 

[MacGyverS2000]

Wow, FlexRay is looking at 10 Mb/s for the initial push... that should make for a useful datalogger in the car. Haven't looked at ByteFlight yet...


Dan
Owner

http://www.Hi-TecDesigns.com