Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Help identifying this seal Please

Status
Not open for further replies.

Reddog_2

Mechanical
Jun 25, 2021
1
Hi, I'm hoping someone can help me identify the manufacturer or the type of this mechanical seal in the attached pictures . I will try to explain it as best i can. it is out of an old clayton waterbrake absorber. the stationary part of the seal is a cartridge with the spring loaded contact ring. its pressed stainless housing seals on the outside diameter. on the seal i found the numbers 91-275 931-001 but cant find anything on these numbers

the rotating part id turned stainless that appears to have carbon film on the sealing face, it has an oring in 1 groove and a backup seal in the other groove on the outside diameter that sits in a counterbore on the impeller. clayton shut down there dyno section so told me to jog on.

Any help would be awesome


seal1_w3hvee.jpg
seal2_jymoji.jpg
Seal3_cv95yy.jpg
 
Replies continue below

Recommended for you

If you can't identify the seal from the parts, it's sometimes easier to find a replacement that fits the seal cavity. If you can get measurements of the seat bore, shaft diameter, and installed height this should lead you to a replacement seal.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor