Melko
Civil/Environmental
- Mar 25, 2002
- 53
I bought a large selection of 3d objects in order to use them in my Architectural Desktop drawings, but they are saved as a simple block even if they are very complex.
Is there a way to divide the block?
A.D. do not even sees them as solid when I tried the "separate"
I tried to explode, but they become a mess of lines, too hard to use.
Is there a way to divide the block?
A.D. do not even sees them as solid when I tried the "separate"
I tried to explode, but they become a mess of lines, too hard to use.
