Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Help needed - Problem in generating a solid

Thread starter satyasrinivas
Start date Sep 30, 2009

Status: Not open for further replies.

Sep 30, 2009

satyasrinivas

Structural

Hi,

I am trying to create a solid in the assembly section, but I am running into these errors - "The depth reference should not be on the section plane" and "Could not determine feature depth.
#QUICK FIX, #REDEFINE/#REROUTE"

The same technique worked before, so I am clueless what is going wrong. Any suggestions ?

I am trying to generate a solid (PRT0003) using sketch 1. I want this solid to exactly fill in the hole in PRT0002. I am attaching the assembly file.

Thanks
SS