Knurl
Mechanical
- Jul 28, 2004
- 1
Hi Guys,
Can any of you help with fixing the above problem?
I have been using I-Deas 6aM1 for many years but recently my SGi workstation went "belly up" and had to be replaced with a new one. This meant that the software would no longer work due to node-locking to the old machine.
I installed the software on a new disk and managed, with some difficulty, to get a password for it. I loaded all the required patches and sub-systems (Irix 6.2) that I believe are necessary.
When I tried to run the software the start up screen appeared but would not enter the application and the following error was reported "Orbix environment not established."
Now I have seen this error before but I cannot for the life of me remember how to put it right.
Can anyone help?
Thanks.
Can any of you help with fixing the above problem?
I have been using I-Deas 6aM1 for many years but recently my SGi workstation went "belly up" and had to be replaced with a new one. This meant that the software would no longer work due to node-locking to the old machine.
I installed the software on a new disk and managed, with some difficulty, to get a password for it. I loaded all the required patches and sub-systems (Irix 6.2) that I believe are necessary.
When I tried to run the software the start up screen appeared but would not enter the application and the following error was reported "Orbix environment not established."
Now I have seen this error before but I cannot for the life of me remember how to put it right.
Can anyone help?
Thanks.