Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IFRs on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hi, I am trying to configure the

Thread starter NXJockey
Start date May 28, 2012

Status: Not open for further replies.

May 28, 2012

NXJockey

Automotive

Hi,

I am trying to configure the ICEM UG mesher interface 12.1 for use with 64bit NX7.5 (ie use the ICEM mesher from wirhin NX) I did this for NX6 (32bit)

ICEM (64bit) works fine on the client, but i cant get it to work with NX7.5 (64bit). Any tips for somthing obvious i am missing?

Cheers

NXj