Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hi, I applied seismic load in SA

Status
Not open for further replies.
Replies continue below

Recommended for you

Problems could be many. Some things to check:
How is your mass source defined for the modal analysis?
What are the modal analysis settings? Response spectrum analysis settings?
What load combinations include the response spectrum results? Have you confirmed that your current run is including those load combinations?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor