Hole callouts in flat-pattern

[cubalibre000]

Hi,
I'm not able to add hole callouts in the flat-pattern.
I need to enable something or set something files ?

Thank you...

Using NX 7.0.1.7 MP3 and TC8.1

 

[JohnRBaker]

Were the holes created as 'Hole' features or as cutouts?

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

Holes was created as hole feature.
I attach the part.

Thank you...

Using NX 7.0.1.7 MP3 and TC8.1

 

[JohnRBaker]

I think you should contact GTAC and have them look at this.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[cubalibre000]

The response is that the "hole diameter" option is available only when you have a "lightening cutout" created with the "hole" Type option.

Insert --> Punching --> Lightening Cutout

This command is available only in the Aerospace Sheet Metal environment.


Thank you...

Using NX 7.0.1.7 MP3 and TC8.1