Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole dimension tolerances on prints

Status
Not open for further replies.

bearisle

Mechanical
Jun 2, 2004
77
Might not be in the right forum....I am looking for a good way to put a blanket statement in my title block to cover HOLE dimension tolerances. I currently use linear dimensions as follows
x.x = +/- 0.1
x.xx = +/- 0.015
x.xxx = +/- 0.005
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor