Hole position sketch not updating. What could be wrong?

[descatia]

Hello, when I put a hole in a face, i use the positioning sketch, and I dimension the little yellow xy axes that comes up. However when I click in the dimension and change the value the axes does not move, and neither does the hole. The hole seems to be stuck at the point where I chose the face.

What am I doing wrong?

Thanks a lot in advance for your interest and answers.

 

[JeniaL]

go to sketch and try to change dimensions. does point moves when you change dimensions? if not delete existing point create new one and then put dimensions on. must work.

 

[ferdo]

Hi,

When you put a dimension, you have to pick the point itself, not the axis. Those are sketch origin axis.

Regards
Fernando

https://picasaweb.google.com/102257836106335725208

- Romania

https://picasaweb.google.com/103462806772634246699/

- EU

 

[itsmyjob]

What Jenial and Ferdo are saying is that the ho;e center position is defined by the point in the sketch, not the sketch axis.

Eric N.
indocti discant et ament meminisse periti ​