Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

Hole table question

Thread starter bmarchand
Start date Dec 16, 2016

Status: Not open for further replies.

Dec 16, 2016

bmarchand

Automotive

When I put a hole table in my drawing it recognizes the holes and puts a diameter and a cb and a depth. Is there a way to recognize as a screw hole or a dowel hole and put in the appropriate fallout notes to go with it?

Brian Marchand-owner
BRM Design
NX 11.0
16G Ram - Nvidia Quadro K4000
Win 7 Pro x64